Our new mini HF Mono Band QRP transceiver to any one amateur band from 1 to 30 MHz. ( SSB / CW / JT65 / PSK / BPSK / FSQ & Old Digi mode)
The transceiver is built on the scheme with a single superheterodyne frequency conversion and four Crystal quartz filter.
The device is controlled by a microcontroller. The frequency synthesizer used as a local oscillator on-chip SI5351
The transceiver is designed to operate in the lower (LSB) / upper (USB) sideband as a phone (ssb) and CW. It is possible to work in digital modes.
Power supply in the 10-14 (13.8 Nominal)
Current consumption in receive mode with an average volume of 100 mA
600-800 mA in transmission mode (mean 700)
Receiver sensitivity better than 0.4 Microvolts
Transmitter Output Power 3 W nominal. (Max 4 W)
Low-pass amplifier Output Power 0.7 W
Intermediate Frequency 6 MHz
Band crystal filter bandwidth 2.9 kHz at -6dB
Switchable LP filter (200,300,600,900,1200,1500,1700,2000,2200,2400,2700,2900 Hz) with a fairly steep slope.
Carrier suppression more than 50dB
Suppression of non-operating side, more than 45 dB
The output power of the transceiver can vary from 1-10 Mhz 2,5 - 4 Watts, 14-30 Mhz 1,5 - 3 Watts, but not worse
LSB / USB
CW / SSB / DIGI
Two AGC mode (Fast / Low)
Signal strength indicator (S-Meter)
Vertical / semi-automatic keyer
Turn on / off key for CW transmission
Enable / disable the transmission of AF signal at the input. For digital modes (DIGI-VOX)
The offset frequency for CW
Self-control for CW
Indication of low voltage
- Volume control
- Built-in speaker
Includes power cord length of 60 cm. 1,3mm x 3,5mm DC Plug
Assembling and sending the transceiver is performed within 18 days. The number of products is limited.
Video review of QRPver-1 v.3 HF Mono band mini QRP transceiver
Transceivers - QRPver-1 v.3 HF Mono band mini QRP transceiver ( SSB / CW / JT65 / PSK / BPSK / FSQ )
- Product Code: qrpver-1 v.3
- Availability: In Stock
- 5 or more $170.00
You save $5.00!